Logitech Pebble Keys 2 K380s is a Keyboard and Mouse bundle that can be connected to your laptop using either a USB Dongle or Bluetooth Connection. Follow the steps below based on your available options:
USB Connection
This keyboard and mouse bundle comes with a USB Dongle for an easy connection to your laptop. The dongle can be found inside the mouse after removing the top magnetic part of the mouse.
Bluetooth Connection
Step 1: Insert or Check Batteries
Both devices come with batteries pre-installed:
Slide open the battery compartment underneath each device.
Ensure the AAA batteries are seated correctly.
Close the compartment.
Switch the Power On toggle underneath each device.
A power indicator light should turn on momentarily.
Step 2: Put Devices in Pairing Mode
Mouse (Pebble M350s):
Press and hold the button at the bottom of the mouse (next to the power switch) for 3 seconds until the LED starts blinking blue. This means it’s in pairing mode.
Keyboard (K380s):
Press and hold one of the Easy-Switch keys (labeled F1, F2, F3) for 3 seconds. Depending on your laptop configuration, you might need to press FN+F1, F2, F3.
The corresponding LED will start blinking rapidly – now it’s ready to pair.
Step 3: Connect via Bluetooth
Go to Windows Settings > Devices > Bluetooth settings on your device.
Ensure Bluetooth is enabled on your device, then click on Add Bluetooth or other device → Bluetooth.
Select "Logitech K380s Keyboard" and "Pebble Mouse" from the list.
Confirm any pairing codes if prompted.
- Test the Keyboard and Mouse.
Additional Information - Switch Between Devices
The K380s keyboard supports multi-device switching:
Depending on your laptop setup, press "F1 / F2 / F3" or "FN + F1 / F2 / F3" to toggle between up to three paired devices.
Each key retains its pairing even after power off.